Flame Control 25-Minute Thermal Barrier for Spray Polyurethane Foam Insulation, 60-60A

Fire Proof Your Insulation with Flame Control 25-Minute Thermal Barrier for Spray Foam Polyurethane Insulation

Flame Control 60-60A is a 25-Minute Thermal Barrier for Spray Polyurethane Foam Insulation.  A water-based, low VOC, intumescent latex paint, 60-60A has been tested to NFPA 286 test standards and has been approved for use on spray foam insulation.  Flame Control 60-60A is suitable for use in inhabited (occupied) spaces where spray foam insulation must be coated with a thermal barrier per the IBC.

60-60A should be applied in a single coat, and does not require a primer.  These features make 60-60A the easiest to use, fastest to apply thermal barrier available on the market.  

Performance Information:

⭐ Provides a ULC and NFPA test method qualifying thermal barrier on spray polyurethane foam installations - See Fire Hazard Classification Section.
⭐ Dries by water evaporation to a tough, hard, velvety flat finish.
⭐ Does not leach (lose fire retardancy) on exposure to high humidity.
⭐ Meets all present VOC and environmental/ecological regulations

Recommended Uses:

For application to spray polyurethane foam surfaces in occupied spaces where spray foam insulation must be separated from the interior of the building per IBC Section 2603.4 approval, and on exterior surfaces when protected as above.

Product Characteristics

Product Name	Flame Control No. 60-60A
Type	Water-based Intumescent Fire Retardant Paint
Finish	Flat
Color	Off-White (tintable – mix thoroughly for uniform color)
Thermal Barrier Rating	15-minute thermal barrier on spray polyurethane foam (NFPA 286)
Coverage	80 sq ft / gal (1.95 m²/L) @ 20 mils wet / 10 mils dry
Volume Solids	51 % ± 2 %
Weight Solids	65 % ± 2 %
VOC Content	< 40 g/L (Low VOC)
Dry Time @ 77 °F / 50 % RH	To Touch: 1–2 hours | Recoat: 2–4 hours
Cure Type	Water evaporation
Flash Point	None
Reducer / Cleaner	Water
Shelf Life	12 months (unopened)
Packaging	1 gal & 5 gal containers (approx. 12 lb/gal)
Application Method	Airless spray recommended; brush or roller possible
Recommended Equipment	Graco Mark 4 or 5 (1.35 GPM, 3300 PSI, tip 517–533); 3/8 in hose for first 50 ft, ¼ in x 6 ft whip; remove filters.
Surface Prep	Foam must be clean, dry, firm, and free of dust, oil, wax, or mildew.
Application Temperature	10 °C – 30 °C (50 °F – 86 °F)
Storage Temperature	Store above 10 °C (50 °F); protect from freezing.
Humidity Conditions	Use fans if RH > 65 %; high humidity may extend dry time.
Fire Test Compliance	NFPA 286; IBC Section 803; IRC 316.6; NFPA 101 Life Safety Code