Overview:
Ramuc DS acrylic pool paint is formulated to offer advantages over traditional solvent-based paints. Ramuc DS can be applied to damp surfaces and previously painted chlorinated and synthetic rubber surfaces. Ramuc S will clean up with soap and water and allows the pool to be filled within 3 days after the final application of paint. Acrylic coatings, like Ramuc DS, are the paints of choice where short down times are critical. Water-based acrylics are extremely colorfast and UV resistant. As DS has a flat finish, it may stain easier than higher gloss paints. Because of the nature of the acrylic paint surface, the service life of acrylic water-based paints will wear faster than solvent based coatings.
- DO NOT USE ON FIBERGLASS SURFACES, HOT TUBS, OR SPAS.
- NOT RECOMMENDED FOR BARE CONCRETE OR BARE PLASTER SURFACES. INSTEAD, USE RAMUC HI-BUILD EPOXY.
- NOT RECOMMENDED FOR PREVIOUSLY PAINTED EPOXY SURFACES. INSTEAD, USE EP EPOXY or HI BUILD EPOXY.
- FOR INDOOR POOLS IF PREVIOUS PAINT IS EPOXY OR RUBBER – USE EP EPOXY, HI BUILD EPOXY, or A-2.
Supplies Needed:
- Cleaning Products:
• Ramuc Clean and Prep Solution™. An environmentally safe product that cleans, etches and neutralizes in lieu of the three-step process and a 3500psi power washer. - Painting Supplies:
• Mohair or lambskin roller used for solvent based paints (no thicker than 3/8” nap) NOTE: DO NOT USE A ROLLER WITH CARDBOARD CORE
• Paint brush for detailing
• 5-gallon bucket for boxing (intermixing) paint
• Mechanical mixer; a paddle attachment for a power drill
• Clean, potable water if airless spraying and/or cleaning-up tools and spills - Joint or Crack Filler:
• Hydraulic cement or Vulkem 116 polyurethane sealant. Do not use silicone-based products as paint adhesion will be adversely affected. Vulkem 116 must be top coated before being submerged in chemically treated water.
Coverage:
350-400 square feet per gallon kit on recoats.
(Actual coverage will vary and is dependent upon the texture and profile of the surface.)
Surface Preparation:
Plaster or concrete surfaces should be tested for integrity and soundness. Ramuc coatings are not a repair for weak surfaces. Any minor repairs, such as patching with hydraulic cement or filling of cracks, should be done and allowed to cure prior to surface prep. Follow the manufacturer’s recommendations.
Prepare the surface thoroughly with Ramuc Clean and Prep Solution following the
directions carefully.
Cure Rates:
Outdoor pool: 3 dry days
If rain occurs during the curing process, allow an extra day of dry time for each day of rain. Rain or moisture can cause blistering, color blushing, and the finish could be affected.
Compatiility:
Determine compatibility of existing paint on previously painted surfaces of a pool before painting. Use dark colors for accent painting only, as they may prematurely fade or blister, especially in chemically treated water.
